There are a few unusual factors that can cause your door open by itself.
Stanley garage door opens by itself.
Radio interference causes garage door problems cb radios police radios a nearby radio station or radio tower can also make a garage door open and close on its own.
The first is photoelectric and the second is mechanical.
Garage doors use radio frequencies to open and close.
This can cause it to reopen.
In garage door operators made after 1993 there are required safety features that open the door during the close cycle when they detect something blocking the door.
Your garage door most likely uses two sensors to trigger its reverse mechanism.
Residential electric garage door openers manufactured after 1993 are equipped with two safety mechanisms that operate while the door is closing.
Whether you re using the passcode entry the buttons inside the garage or your remote opener the openers and the garage door itself must be on the same frequency.
Garage door openers operate on one of many frequencies and while it is possible.
Below are three reasons why your garage door opens on its own and some quick fixes you can try.
Yes it s possible although rare for your garage door to open by itself.
If you clear all debris and any buildup from the sensors near the floor of your garage door tracks but the motion of your garage door tends to be partially closing and then reversing and opening again you may have a misaligned sensor.
Richards says it s rare but in some instances a door will open and close by itself because someone else has your code or frequency.
There may also be loose wire connections inside the button housing itself.
This can be fixed by realigning the beams.
If the motor overload protector has been activated wait 10 minutes for the motor to cool down.
Keep in mind that the remote control will not operate the door until the beam sensor has been attached and properly aligned.
This is done with the help of sensors in the motor and on each side of the opening near the floor and mounted on the tracks.
For one of your neighbors remotes to open your garage door it is highly unlikely.
This can get misaligned though the two sensors can get out of align the beam cut off and the system interprets this as an object in the way of the door closing.
If your stanley garage door opener will not work ensure that it is plugged into a live 120 volt outlet.
The symptom of this is a garage door that is in constant motion opening fully then immediately descending only to start the same cycle again.
As these wires short against the housing the electrical impulse causes the door opener to activate.
A garage door that randomly opens by itself is not a common problem but does occur from.
